Scroll to navigation

GNUNET-TESTBED-PROFILER(1) General Commands Manual GNUNET-TESTBED-PROFILER(1)

NAME

gnunet-testbed-profilerprofiling driver for the testbed

SYNOPSIS

gnunet-testbed-profiler [-c FILENAME | --config=FILENAME] [-e COUNT | --num-errors=COUNT] [-H FILENAME | --hosts=FILENAME] [-h | --help] [-L LOGLEVEL | --loglevel=LOGLEVEL] [-l LOGFILE | --logfile=LOGFILE] [-n | --non-interactive] [-p COUNT | --num-peers=COUNT] [-v | --version]

DESCRIPTION

gnunet-testbed-profiler is a command line profiling driver for the testbed.

OPTIONS

FILENAME | FILENAME
Use the configuration file FILENAME.
COUNT | COUNT
Tolerate COUNT number of continuous timeout failures.
FILENAME | FILENAME
Name of the file with the login information for the testbed.
|
Print short help on options.
LOGLEVEL | LOGLEVEL
Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
LOGFILE | LOGFILE
Configure logging to write logs to LOGFILE.
|
Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.
COUNT | COUNT
Create COUNT number of peers.
|
Print GNUnet version number.

SEE ALSO

The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command

info gnunet

should give you access to the complete handbook,

info gnunet-c-tutorial

will give you access to a tutorial for developers.

Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).

BUGS

Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <gnunet-developers@gnu.org>.

September 13, 2014 Debian