|GNUNET-TRANSPORT(1)||General Commands Manual||GNUNET-TRANSPORT(1)|
gnunet-transportis a tool to access various functions of GNUnet's transport subsystem from the command-line. Most of these are not expected to be useful for end-users. gnunet-transport can be used to evaluate the performance of the transports, force a peer to connect to another peer (if possible). Other functions should be added in the near future.
- Measure how fast we are receiving data (from all connections). On exit, the data rate will be reported. Runs until aborted with CTRL-C.
- configuration file to use
- Force disconnection from a peer (used in conjunction with
-p). Note that you can use the gnunet-ats command-line tool to suggest connects.
- Provide information about all connect and disconnect events (continuously).
- Print the help page.
- Print information about our current connections (once).
- Change the loglevel. Possible values for LOGLEVEL are ERROR, WARNING, INFO and DEBUG.
- Configure logging to write logs to LOGFILE.
- Print information about our current connections (continuously).
- The peer identity to connect to or monitor.
- Monitor session state of transport plugins.
- Transmit (dummy) traffic as quickly as possible to the peer specified with
-poption. The rate will still be limited by the quota(s) determined by the peers (ATS subsystem). Will run until CTRL-C is pressed or until the connection to the other peer is disrupted.
- Print out the version number.
- be verbose
SEE ALSO¶gnunet-arm(1), gnunet-ats(1)
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
should give you access to the complete handbook,
will give you access to a tutorial for developers.
BUGS¶Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <email@example.com>.
|October 17, 2015||Linux 4.19.0-14-amd64|