| EEPRO100-DIAG(8) | System Manager's Manual | EEPRO100-DIAG(8) |
NAME¶
eepro100-diag - EEPROM setup and diagnostic program for Intel EtherExpress Pro100B, and EEPro PCI 10+ ethernet cards.
SYNOPSIS¶
eepro100-diag [options]
DESCRIPTION¶
eepro100-diag is a program that you can use to diagnose problems with ethernet cards based the "Speedo3" chip series: the i82557, '558 and '559. These chips are used on the EtherExpress Pro100B, and EEPro PCI 10+.
OPTIONS¶
These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
- -h, --help
- Show summary of options.
- -V, --version
- Show version of program.
- -v, --verbose
- Verbose mode.
- -q, --quiet
- Be very unverbose.
- -# <cardnum>, --card_num <cardnum>
- Use card number <cardnum>.
- -a, --show_all_registers
- Print all registers.
- -e, --show-eeprom
- Dump EEPROM contents to stdout.
- -E, --emergency-rewrite
- Re-write a corrupted EEPROM.
- -p, --port-base <port>
- Specify port to use.
- -A, --Advertise <mediaype>
- Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
- -F, --new-interface <interface>
- Interface number. Options that make sense are: 10baseT, 10base2, AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense.
- -H, --new-hwaddress <address>
- Set card to a new hardware address.
- -m, --show-mii
- Dump MII management registers.
- -R, --reset
- Reset the transceiver.
- -T, --test
- Do register and SRAM test.
- -w, --write-EEPROM <values>
- Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!
- -f, --force-detection
- Try to identify the card, even if it is active.
- -t, --chip-type <card>
- Explicitly set the chip. To get all valid numbers, run eepro100-diag with the options '-t -1'.
SEE ALSO¶
mii-diag(8)
AUTHOR¶
eepro100-diag was written and is still maintained by Donald Becker <becker@scyld.com>. This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).
| February 18, 2002 |