table of contents
VIRTIO_BLK(4) | Device Drivers Manual | VIRTIO_BLK(4) |
NAME¶
virtio_blk
—
VirtIO Block driver
SYNOPSIS¶
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device virtio_blk
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
virtio_blk_load="YES"
DESCRIPTION¶
The virtio_blk
device driver provides
support for VirtIO block devices.
LOADER TUNABLES¶
Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf(5).
- hw.vtblk.no_ident
- hw.vtblk.X.no_ident
-
These tunables disable retrieving the device identification string from the hypervisor either globally or per-device. The default value is 0.
- hw.vtblk.writecache_mode
- hw.vtblk.X.writecache_mode
-
These tunables determine the write cache mode globally or per-device. The mode can changed only if the ConfigWCE feature is negotiated. Set to 0 for writethrough mode, 1 for writeback mode, and -1 to leave it as-is. The default value is to leave as-is.
SYSCTL VARIABLES¶
The following variables are available as sysctl(8) variables.
- dev.vtblk.X.writecache_mode
-
The write cache mode of the device can be either writethrough (0) or writeback (1). If the ConfigWCE feature is negotiated, the write cache mode can be toggled between writethrough and writeback.
SEE ALSO¶
HISTORY¶
The virtio_blk
driver was written by
Bryan Venteicher
<bryanv@FreeBSD.org>.
It first appeared in FreeBSD 9.0.
July 2, 2013 | Debian |