table of contents
MGE-UTALK(8) | NUT Manual | MGE-UTALK(8) |
NAME¶
mge-utalk - Driver for MGE UPS SYSTEMS UTalk protocol equipment
SYNOPSIS¶
mge-utalk -h
mge-utalk -a UPS_NAME [OPTIONS]
Note
This man page only documents the hardware-specific features of the mge-utalk driver. For information about the core driver, see nutupsdrv(8).
SUPPORTED HARDWARE¶
mge-utalk supports the following legacy units, using the MGE UTalk protocol:
This driver also support some newer models with backward UTalk compatibility, such as Pulsar Evolution and Pulsar EXtreme C. As these models also support the SHUT protocol, prefer mge-shut for serial communication, or use the USB port, if available, with the usbhid-ups driver.
EXTRA ARGUMENTS¶
This driver supports the following optional settings in the ups.conf(5):
lowbatt=num
The factory default value is 30 (in percent), and can be settable depending on the exact model.
offdelay=num
The default value is 20 (in seconds).
ondelay=num
The default value is 1 (in minutes).
oldmac
KNOWN ISSUES¶
Repetitive timeout and staleness¶
Older models, such as ES/ESV ones, might report repetitive "data stale" errors. This is due to the fact that these models don’t support too much polling. To solve this problem, add "pollinterval=20" in ups.conf, and change the value of MAXAGE to 25 in upsd.conf, and DEADTIME to 25 in upsmon.conf.
AUTHORS¶
SEE ALSO¶
The core driver¶
Internet resources¶
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/
01/25/2023 | Network UPS Tools 2.8.0 |