Scroll to navigation

RSPARMS(8) Linux System Managers Manual RSPARMS(8)

NAME

rsparms - Configure the Rose interface.

SYNOPSIS

rsparms -nodes add|del address[/mask] port neigh [digis...]

rsparms -nodes list

rsparms -call <callsign>|none

rsparms -version

DESCRIPTION

This program is used to manipulate the routing tables of the Rose network layer. To set up a new route to a Rose node in the routing tables you must use the nodes option. All of the parameters are needed to add the node. It is probably best to illustrate with an example:

rsparms -nodes add 2080192303 144 F1OAT-11

This creates a new route to a distant node with the address 2080192303 and the packets for that node should be sent on AX.25 port 144 to my immediate neighbour F1OAT-11 without going through any digipeaters. For example to set up the same node but via a digipeater I would use:

rsparms -nodes add 2080192303 144 F1OAT-11 F6PRA-9

It is also possible to remove a route to a distant node with the same command except that the “add” is replaced by a “del”. The other parameters must also be present. If the node has no other routes then the node will be deleted, and the neighbour node that the connections go via may also be deleted if no other node route uses it.

You may list the configured Rose routes using the following syntax:

rsparms -nodes list

This program may also be used to set up a common AX.25 level 2 callsign that will be used for the ROSE node. By default no special level 2 callsign is set, but setting it will replace any existing level 2 callsign and register another one. Setting the callsign to “none” will remove the level 2 callsign. For example:

rsparms -call VK2KTJ-10

would set the callsign used by Rose internode traffic to VK2KTJ-10.

OPTIONS

Display the version information.

FILES

/etc/ax25/axports
/etc/ax25/rsports

SEE ALSO

call(1), rose(4), axports(5), rsports(5), rsparms(8).

AUTHOR

Jonathan Naylor G4KLX <g4klx@g4klx.demon.co.uk>

15 July 2011 Linux