chcpu - configure CPUs
chcpu -p mode
chcpu can modify the state of CPUs. It can enable or disable CPUs, scan for new CPUs, change the CPU dispatching mode of the underlying hypervisor, and request CPUs from the hypervisor (configure) or return CPUs to the hypervisor (deconfigure).
Some options have a cpu-list argument. Use this argument to specify a comma-separated list of CPUs. The list can contain individual CPU addresses or ranges of addresses. For example, 0,5,7,9-11 makes the command applicable to the CPUs with the addresses 0, 5, 7, 9, 10, and 11.
- -c, --configure cpu-list
- Configure the specified CPUs. Configuring a CPU means that the hypervisor takes a CPU from the CPU pool and assigns it to the virtual hardware on which your kernel runs.
- -d, --disable cpu-list
- Disable the specified CPUs. Disabling a CPU means that the kernel sets it offline.
- -e, --enable cpu-list
- Enable the specified CPUs. Enabling a CPU means that the kernel sets it online. A CPU must be configured, see -c, before it can be enabled.
- -g, --deconfigure cpu-list
- Deconfigure the specified CPUs. Deconfiguring a CPU means that the hypervisor removes the CPU from the virtual hardware on which the Linux instance runs and returns it to the CPU pool. A CPU must be offline, see -d, before it can be deconfigured.
- -p, --dispatch mode
- Set the CPU dispatching mode (polarization). This option has an effect only if your hardware architecture and hypervisor support CPU polarization. Available modes are:
- The workload is spread across all available CPUs.
- The workload is concentrated on few CPUs.
chcpu has the following exit status values:
- partial success
Copyright IBM Corp. 2011
The chcpu command is part of the util-linux package and is available from Linux Kernel Archive.