table of contents
other versions
- buster 1.10.0-2+b3
DPM-MODIFYFS(1) | DPM Administrator Commands | DPM-MODIFYFS(1) |
NAME¶
dpm-modifyfs - modify the parameters of a disk pool filesystemSYNOPSIS¶
dpm-modifyfs --server fs_server --fs fs_name [ --st status ] [ --weight weight ] [ --help ]DESCRIPTION¶
dpm-modifyfs modifies the parameters of a disk pool filesystem.This command requires ADMIN privilege.
OPTIONS¶
- server
- specifies the host name of the disk server where this filesystem is mounted.
- fs
- specifies the mount point of the dedicated filesystem.
- status
- New status of this filesystem. It can be set to 0 (enabled read/write) or DISABLED or RDONLY. This can be either alphanumeric or the corresponding numeric value.
- weight
- specifies the weight of the filesystem. This is used during the filesystem selection. The value must be positive. It is recommended to use a value lower than 10.
EXAMPLE¶
dpm-modifyfs --server sehost --fs /data --st RDONLY
EXIT STATUS¶
This program returns 0 if the operation was successful or >0 if the operation failed.SEE ALSO¶
dpm(1), dpm_modifyfs(3)$Date: 2011-05-19 13:04:02 +0200 (Thu, 19 May 2011) $ | LCG |