table of contents
ONEAC(8) | NUT Manual | ONEAC(8) |
NAME¶
oneac - Driver for Oneac UPS equipmentNOTE¶
This man page only documents the hardware-specific features of the oneac driver. For information about the core driver, see nutupsdrv(8).SUPPORTED HARDWARE¶
This driver supports various Oneac UPS families:If your UPS is equipped with the Basic Interface card, use the genericups(8) driver.
EXTRA ARGUMENTS¶
This driver supports the following optional settings in the ups.conf(5) file:testtime=num
offdelay=num
INSTANT COMMANDS¶
This driver supports the following Instant Commands. (See upscmd(8))All UPS units¶
shutdown.returnshutdown.stop
shutdown.reboot
test.failure.start
test.battery.start.quick
test.battery.stop
All ON UPS units¶
reset.input.minmaxNewer ON UPS units¶
test.panel.starttest.battery.start.deep
reset.input.minmax
beeper.enable
beeper.disable
beeper.mute
WRITABLE VARIABLES¶
See upsrw(8) to see what variables are writable for the UPS.Note
If your UPS supports writing battery.runtime.low, the new set value is to be entered in minutes (up to 99) but the reported value is reported in seconds (set value * 60).
Note
If your UPS supports input.transfer.low and input.transfer.high, those values are used to create an allowable output range. The UPS will do what it can to keep the output voltage value within the defined range (for example: tap change or switch to inverter).
AUTHOR¶
Bill Elliot <bill@wreassoc.com>, Eric Lawson <elawson@inficad.com>SEE ALSO¶
The core driver:¶
nutupsdrv(8)Internet resources:¶
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/12/29/2015 | Network UPS Tools 2.7.3. |