NAME¶

gnunet-testbed-profiler — profiling driver for the testbed

SYNOPSIS¶

DESCRIPTION¶

gnunet-testbed-profiler is a command line profiling driver for the testbed.

OPTIONS¶

-c FILENAME | --config=FILENAME

Use the configuration file FILENAME.

-e COUNT | --num-errors=COUNT

Tolerate COUNT number of continuous timeout failures.

-H FILENAME | --hosts=FILENAME

Name of the file with the login information for the testbed.

-h | --help

Print short help on options.

-L LOGLEVEL | --loglevel=LOGLEVEL

Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.

-l LOGFILE | --logfile=LOGFILE

Configure logging to write logs to LOGFILE.

-n | --non-interactive

Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.

-p COUNT | --num-peers=COUNT

Create COUNT number of peers.

-v | --version

Print GNUnet version number.

SEE ALSO¶

The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command

should give you access to the complete handbook,

will give you access to a tutorial for developers.

Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).

BUGS¶

Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <gnunet-developers@gnu.org>.