General options:¶

-h --help

This help

--config [~/]<path to config file>

Give a config file to use. If it starts with '~/', path is at home dir. Each line in config file is one option, '-' or '--' must not be given!

-v --verbose <level> | <level>,<category>[,<category>[,...]] | list

Use 'list' to get a list of all levels and categories. Verbose level: digit of debug level (default = '3') Verbose level+category: level digit followed by one or more categories -> If no category is specified, all categories are selected

-v --verbose date

Show date with debug output

-s --serial-device <device>

Serial device (default = '/dev/ttyUSB0')

-b --baud-rate <baud>

Serial baud rate (default = 9600)

-w --write-pdu <filename>

Write PDU to file (sniffer only)

SIM card simulator options:¶

-E --eeprom <name>

Stores and reads EEPROM data to/from file. The file is stored at "~/osmocom/analog/sim_<name>.eeprom". If the file dos not exit yet, the default values are used. Values are always overwritten with card data, if defined.

-F --futln <phone number>

Give 7 digits subscriber ID (default = '2222001')

--sicherung <security code>

Card's security code for simple authentication (default = '3103')

--kartenkennung <card ID>

Card's ID. Not relevant! (default = '3')

--sonder <special code>

Special codes are used for service cards (default = '0')

--wartung <maitenance code>

May define features of service cards (default = '65535')

-P --pin <pin> | 0000

Give 4 .. 8 digits of pin. Use '0000' to disable. (default = '0000') This will also reset the PIN error counter and unlocks the card.

-D --directory <location> <number> <name> [--directory ...]

Give storage location '01' .. '80'. To erase give "" as number and name. This option can be given multiple times for more entries.

-A --authenticate 0x...

Give 64 Bit value for authentication response. (default = all bits 1)

Commands are:¶

sniff - To passively sniff SIM card communication sim - To simulate a SIM card

?[0;33m?[1;31mDOPTIONS?[0;m?[0;33m ?[1;31mERROR?[0;m?[0;33m options.c:302 Given command line option '--version' is not a valid option, use '-h' for help!?[0;m