Scroll to navigation

REMOTETRX(1) User Manuals REMOTETRX(1)

NAME

remotetrx - The SvxLink remote transceiver application

SYNOPSIS

remotetrx [--help] [--daemon] [--logfile=log file] [--config=configuration file] [--pidfile=pid file] [--runasuser=user name]

DESCRIPTION

remotetrx is the SvxLink remote transceiver application. It is used to connect to a receiver and/or transmitter and then the main SvxLink server can connect to the remote transceiver server via TCP/IP to get audio to/from it.

It is also possible to link via RF instead of via TCP/IP. An example use of the latter would be if the repeater is placed in a remote location where there is no network. Then networked remote receivers can be linked up to the repeater via RF from a link site where network is available.

The setup is pretty straight forward. The setup of a receiver or transmitter is done in the same way as in the SvxLink server so use the svxlink.conf(5) manual page as a reference for that. The remotetrx specific configuration is described in the remotetrx.conf(5) manual page.

On the SvxLink server side you need to configure a networked receiver/transmitter. That is described in the svxlink.conf(5) manual page in the Networked Receiver/Transmitter Section. If using multiple receivers you also want to configure a voter and make proper calibration of the signal level detector on each receiver.

OPTIONS

Print a help message and exit.
Start the SvxLink remote receiver server as a daemon.
Start RemoteTrx as the specified user. The switch to the new user will happen after the log and pid files has been opened.
Specify a log file to put all output into. Both stdout and stderr will be redirected to the log file.
Specify a pid file to write the process ID into.
Specify which configuration file to use.

FILES

/etc/svxlink/remotetrx.conf (or deprecated /etc/remotetrx.conf)
The system wide configuration file. See remotetrx.conf(5) for further details.
~/.svxlink/remotetrx.conf
Per user configuration file. See remotetrx.conf(5) for further details.
/etc/svxlink/remotetrx.d/*
Additional configuration files. This directory is setup by the CFG_DIR configuration variable.

ENVIRONMENT

Set this environment variable to 1 if you get an error about ioctl: Broken pipe during remotetrx server startup when using OSS audio.
Set this environment variable to 0 to stop the Alsa audio code from writing zeros to the audio device when there is no audio to write available. ASYNC_AUDIO_UDP_ZEROFILL Set this environment variable to 1 to enable the UDP audio code to write zeros to the UDP connection when there is no audio to write available.
Used to find the per user configuration file.

AUTHOR

Tobias Blomberg (SM0SVX) <sm0svx at svxlink dot org>

REPORTING BUGS

Bugs should be reported using the issue tracker at https://github.com/sm0svx/svxlink.

Questions about SvxLink should not be asked using the issue tracker. Instead use the group set up for this purpose at groups.io: https://groups.io/g/svxlink

SEE ALSO

svxlink(1), remotetrx.conf(5), svxlink.conf(5), siglevdetcal(1)

AUGUST 2021 Linux