Scroll to navigation

CTAU(4) Device Drivers Manual (i386) CTAU(4)

NAME

ctaudriver for synchronous Cronyx Tau WAN adapters

SYNOPSIS

device ctau

Additional options:
device sppp
options NETGRAPH
options NETGRAPH_CRONYX

In /boot/device.hints:
hint.ctau.0.at="isa"
hint.ctau.0.port="0x240"
hint.ctau.0.irq="15"
hint.ctau.0.drq="7"

DEPRECATION NOTICE

The ctau driver is not present in FreeBSD 13.0 and later.

DESCRIPTION

The ctau driver needs either sppp(4) or netgraph(4). Which one to use is determined by the NETGRAPH_CRONYX option. If this option is present in your kernel configuration file, the ctau driver will be compiled with netgraph(4) support. Otherwise, it will be compiled with sppp(4) support.

The base I/O port address specified in /boot/device.hints must match the port address set by the jumpers on the board. The DMA I/O channel and interrupt request numbers are configured by software at adapter initialization. Legal values are:

Port:
0x200, 0x220, 0x240, 0x260, 0x280, 0x2a0, 0x2c0, 0x2e0, 0x300, 0x320, 0x340, 0x360, 0x380, 0x3a0, 0x3c0, 0x3e0
IRQ:
3, 5, 7, 10, 11, 12, 15
DMA:
5, 6, 7

The ctau driver supports autodetection. As for all non-PNP hardware, using autodetection could lead to some potential problems with other devices during the hardware detection process. It is always better to specify hardware resources manually.

Refer to sconfig(8) for information about the ctau adapter configuration.

HARDWARE

The ctau driver supports the following cards:

  • Cronyx Tau (RS-232/V.35)
  • Cronyx Tau/R (RS-530/RS-449)
  • Cronyx Tau/E1 (fractional E1)
  • Cronyx Tau/G703 (unframed E1)

SEE ALSO

cp(4), cx(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)

HISTORY

The ctau driver was added in FreeBSD 5.3 and FreeBSD 4.10. The ctau driver for previous versions of FreeBSD is available from http://www.cronyx.ru/.

March 2, 2020 Debian