| GIF(4) | Device Drivers Manual | GIF(4) | 
NAME¶
gif — generic
    tunnel interface
SYNOPSIS¶
device gif
DESCRIPTION¶
The gif interface is a generic tunnelling
    device for IPv4 and IPv6. It can tunnel IPv[46] traffic over IPv[46].
    Therefore, there can be four possible configurations. The behavior of
    gif is mainly based on RFC2893 IPv6-over-IPv4
    configured tunnel. On NetBSD,
    gif can also tunnel ISO traffic over IPv[46] using
    EON encapsulation. Note that gif does not perform
    GRE encapsulation; use gre(4) for GRE encapsulation.
Each gif interface is created at runtime
    using interface cloning. This is most easily done with the
    “ifconfig
    create” command or using the
    ifconfig_⟨interface⟩
    variable in rc.conf(5).
To use gif, the administrator needs to
    configure the protocol and addresses used for the outer header. This can be
    done by using ifconfig(8) tunnel,
    or SIOCSIFPHYADDR ioctl. The administrator also
    needs to configure the protocol and addresses for the inner header, with
    ifconfig(8). Note that IPv6 link-local addresses (those
    that start with fe80::) will be automatically
    configured whenever possible. You may need to remove IPv6 link-local
    addresses manually using ifconfig(8), if you want to
    disable the use of IPv6 as the inner header (for example, if you need a pure
    IPv4-over-IPv6 tunnel). Finally, you must modify the routing table to route
    the packets through the gif interface.
The gif device can be configured to be ECN
    friendly. This can be configured by IFF_LINK1.
ECN friendly behavior¶
The gif device can be configured to be ECN
    friendly, as described in
    draft-ietf-ipsec-ecn-02.txt. This is turned off by
    default, and can be turned on by the IFF_LINK1
    interface flag.
Without IFF_LINK1,
    gif will show normal behavior, as described in
    RFC2893. This can be summarized as follows:
- Ingress
 - Set outer TOS bit to 
0. - Egress
 - Drop outer TOS bit.
 
With IFF_LINK1,
    gif will copy ECN bits (0x02
    and 0x01 on IPv4 TOS byte or IPv6 traffic class
    byte) on egress and ingress, as follows:
- Ingress
 - Copy TOS bits except for ECN CE (masked with 
0xfe) from inner to outer. Set ECN CE bit to0. - Egress
 - Use inner TOS bits with some change. If outer ECN CE bit is
      
1, enable ECN CE bit on the inner. 
Note that the ECN friendly behavior violates RFC2893. This should be used in mutual agreement with the peer.
Security¶
A malicious party may try to circumvent security filters by using
    tunnelled packets. For better protection, gif
    performs both martian and ingress filtering against the outer source address
    on egress. Note that martian/ingress filters are in no way complete. You may
    want to secure your node by using packet filters. Ingress filtering can
    break tunnel operation in an asymmetrically routed network. It can be turned
    off by IFF_LINK2 bit.
Miscellaneous¶
By default, gif tunnels may not be nested.
    This behavior may be modified at runtime by setting the
    sysctl(8) variable
    net.link.gif.max_nesting to the desired level of
    nesting.
SEE ALSO¶
gre(4), inet(4), inet6(4), ifconfig(8)
R. Gilligan and E. Nordmark, Transition Mechanisms for IPv6 Hosts and Routers, RFC2893, http://tools.ietf.org/html/rfc2893, August 2000.
Sally Floyd, David L. Black, and K. K. Ramakrishnan, IPsec Interactions with ECN, December 1999, draft-ietf-ipsec-ecn-02.txt.
HISTORY¶
The gif device first appeared in the WIDE
    hydrangea IPv6 kit.
BUGS¶
There are many tunnelling protocol specifications, all defined
    differently from each other. The gif device may not
    interoperate with peers which are based on different specifications, and are
    picky about outer header fields. For example, you cannot usually use
    gif to talk with IPsec devices that use IPsec tunnel
    mode.
If the outer protocol is IPv4, gif does
    not try to perform path MTU discovery for the encapsulated packet (DF bit is
    set to 0).
If the outer protocol is IPv6, path MTU discovery for encapsulated
    packets may affect communication over the interface. The first
    bigger-than-pmtu packet may be lost. To avoid the problem, you may want to
    set the interface MTU for gif to 1240 or smaller,
    when the outer header is IPv6 and the inner header is IPv4.
The gif device does not translate ICMP
    messages for the outer header into the inner header.
In the past, gif had a multi-destination
    behavior, configurable via IFF_LINK0 flag. The
    behavior is obsolete and is no longer supported.
| October 21, 2018 | Debian |