enum wiphy_flags {
  WIPHY_FLAG_CUSTOM_REGULATORY,
  WIPHY_FLAG_STRICT_REGULATORY,
  WIPHY_FLAG_DISABLE_BEACON_HINTS,
  WIPHY_FLAG_NETNS_OK,
  WIPHY_FLAG_PS_ON_BY_DEFAULT,
  WIPHY_FLAG_4ADDR_AP,
  WIPHY_FLAG_4ADDR_STATION,
  WIPHY_FLAG_CONTROL_PORT_PROTOCOL,
  WIPHY_FLAG_IBSS_RSN,
  WIPHY_FLAG_MESH_AUTH,
  WIPHY_FLAG_SUPPORTS_SCHED_SCAN,
  WIPHY_FLAG_ENFORCE_COMBINATIONS,
  WIPHY_FLAG_SUPPORTS_FW_ROAM,
  WIPHY_FLAG_AP_UAPSD,
  WIPHY_FLAG_SUPPORTS_TDLS,
  WIPHY_FLAG_TDLS_EXTERNAL_SETUP
};  

tells us the driver for this device has its own custom regulatory domain and cannot identify the ISO / IEC 3166 alpha2 it belongs to. When this is enabled we will disregard the first regulatory hint (when the initiator is REGDOM_SET_BY_CORE).

tells us the driver for this device will ignore regulatory domain settings until it gets its own regulatory domain via its regulatory_hint unless the regulatory hint is from a country IE. After its gets its own regulatory domain it will only allow further regulatory domain settings to further enhance compliance. For example if channel 13 and 14 are disabled by this regulatory domain no user regulatory domain can enable these channels at a later time. This can be used for devices which do not have calibration information guaranteed for frequencies or settings outside of its regulatory domain.

enable this if your driver needs to ensure that passive scan flags and beaconing flags may not be lifted by cfg80211 due to regulatory beacon hints. For more information on beacon hints read the documenation for regulatory_hint_found_beacon

if not set, do not allow changing the netns of this wiphy at all

if set to true, powersave will be enabled by default -- this flag will be set depending on the kernel's default on wiphy_new, but can be changed by the driver if it has a good reason to override the default

supports 4addr mode even on AP (with a single station on a VLAN interface)

supports 4addr mode even as a station

This device supports setting the control port protocol ethertype. The device also honours the control_port_no_encrypt flag.

The device supports IBSS RSN.

The device supports mesh authentication by routing auth frames to userspace. See NL80211_MESH_SETUP_USERSPACE_AUTH.

The device supports scheduled scans.

Set this flag to enforce interface combinations for this device. This flag is used for backward compatibility only until all drivers advertise combinations and they will always be enforced.

The device supports roaming feature in the firmware.

The device supports uapsd on AP.

The device supports TDLS (802.11z) operation.

The device does not handle TDLS (802.11z) link setup/discovery operations internally. Setup, discovery and teardown packets should be sent through the NL80211_CMD_TDLS_MGMT command. When this flag is not set, NL80211_CMD_TDLS_OPER should be used for asking the driver/firmware to perform a TDLS operation.

Author.